The thread must pass around this disk on its way to the bobbin in order to put tension on the thread so it will wind properly. It is probably on the left of the machine and may or may not be part of a thread guide. To insure that the thread winds up and down the bobbin and not off the top or bottom, there is probably a metal bobbin tension disk that the thread must pass around before it goes to the bobbin. After about ten turns, or when the winding thread is secure, you can stop the machine and cut off this 3 or 4 inch tail. Pull about 3 or 4 inches out of the hole and hold on to it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |